|
|
#6
29-06-13, 09:47
|
||||
|
||||
its the part that goes into the hammer and forms the head onto the outside. the bucking bar / block is what is placed onto the inside and prevent the rivet slipping whilst being formed.
the snap is the forming end of the job  here are some old pics of my first snap prior to it being hardened (they are a black / blue colour after this process) I have set around 400 rivets with my first snap and its still going strong, some on my project and some on other bits and bobs.   the tool shown is machined for guns with 3/8 shank tools.
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). Last edited by RichardT10829; 29-06-13 at 10:01. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| custom Rivet snaps now available | RichardT10829 | For Sale Or Wanted | 4 | 09-02-12 12:52 |
| rivet forming tools ? | RichardT10829 | The Carrier Forum | 19 | 06-01-10 08:06 |
| 40mm Anti-Aircraft Gun - Canadian produced C Mk 1 on platform C Mark 2 - Bofors | Hanno Spoelstra | WW2 Military History & Equipment | 4 | 11-08-04 23:23 |
Threaded Mode