|
|
#22
04-06-14, 21:47
|
|||
|
|||
I'll try and remember to bring a thread gauge home from work to confirm the pitch.
All I did was work out the diameter and machine the thread at the correct TPI a little at a time, trying the "nut" until I got a good fit. It'll be easy on a cnc mill, I was using an old fashioned Myford, winding it off and reversing before it bottoms out. Not something I want to do again  John's the man for the job 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Starting | Harry Moon | The Softskin Forum | 6 | 23-07-13 23:16 |
| starting handle cover | Maurice Donckers | The Carrier Forum | 0 | 15-11-12 20:47 |
| Starting restoration of LAAT | maverick | The Restoration Forum | 35 | 22-08-09 16:38 |
| Hot engine starting | Barry Read | The Carrier Forum | 17 | 13-05-06 19:25 |
| Jeep Starting Point | Campbell Finlay | The Softskin Forum | 5 | 04-01-05 08:47 |
Threaded Mode