|
|
#22
01-12-15, 04:23
|
||||
|
||||
There were two types of regulator housing. The one with clamp around the center is the T-16 early pattern. Latter looks just like those used in a jeep but it has higher capacity guts being 12v 55amp which were the same as found on the U.S. half-tracks.
Vintage Power Wagons in the USA produced electronic replacement guts to fit the regulator housings. Not sure if they still make them or not but it's what I had in my carrier. http://www.mapleleafup.net/forums/showthread.php?t=9136 Message #161 in my old carrier restoration thread shows the later style regulator housing for reference. Guts should fit in either housing though since its a digital circuit board.
__________________
David Gordon - MVPA # 15292 '41 Willys MB British Airborne Jeep '42 Excelsior Welbike Mark I '43 BSA Folding Military Bicycle '44 Orme-Evans Airborne Trailer No. 1 Mk. II '44 Airborne 100-Gallon Water Bowser Trailer '44 Jowett Cars 4.2-Inch Towed Mortar '44 Daimler Scout Car Mark II '45 Studebaker M29C Weasel Last edited by Hanno Spoelstra; 01-12-15 at 09:11. Reason: corrected link to message #161 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| up and running | Bob McNeill | The Carrier Forum | 6 | 26-08-12 01:52 |
| Database of Running CMP Changes | Phil Waterman | The Softskin Forum | 2 | 13-12-11 17:16 |
| M37 Running Board | shermanm | For Sale Or Wanted | 1 | 30-04-11 18:36 |
| They are still running ????? | Mike Timoshyk | The Restoration Forum | 0 | 16-07-09 03:13 |
| C-15 Running Specs | Peter Mielke | The Softskin Forum | 6 | 25-10-03 23:21 |
Threaded Mode