2016 at the Hammond Barn

[Bob Carriere]

We acquired 2 brakes last year....one is 30 inches straight bar across the other more useful is a 36 inch pan box brake with multi fingers......both work well up to 16 gauge....... the cargo box 2B1 is a lot of 16 guage with some heavier pieces at 14.

I would be concerned making my own brake for 12 to 14 gauge sheet metal.

We have a smaller Chinese 40 in. shear-roller-vertical brake......good for 18 gauge at the most.....although we have cheated with 16 guage but preheated the sheet metal for a clean 90 degree bend.

On a 2B1 cargo box most of the pieces are less than 48 inches...... except the head board piece and the hat shaped section underneath that run the full width.

The tail gate can be done in two sections hidding the but joint under the large strap hinges.

So I have concluded that 72 inches at 12 gauge would do me just fine...... buit need to find the money to buy it.....or pay the local fabricator.

Will carefully watch the utube video next.

Cheers