|
|
#7
13-03-16, 14:14
|
||||
|
||||
bushing
hi John
If it was me doing it, I would make the bushes in a lathe use a tap to thread the bore > Something like 1045 steel may be OK .045% carbon . http://www.tracytools.com/11-16-x-11-tpi You need a fair bit of grunt to tap that diameter thread , strong muscles  I've seen power tapping done on a lathe , never done it myself .
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rubber bushings and grommets on CMP | Jordan Baker | Parts/Sources/Prices | 4 | 19-11-15 02:33 |
| Bronze wheel bushings ? | RichardT10829 | The Carrier Forum | 2 | 04-02-15 00:40 |
| Bren advice | RichardT10829 | The Carrier Forum | 27 | 01-07-12 02:58 |
| Advice on scopes? | rjw nz | The Armour Forum | 1 | 28-09-09 10:12 |
| Advice Column | Mike Timoshyk | The Restoration Forum | 3 | 18-09-07 12:55 |
Threaded Mode