|
|
#8
07-04-16, 11:58
|
|||
|
|||
Terry, weld the nut down close to the block, so that you get the most heat, relative expansion, etc. after the weld has cooled a bit and while there is still some heat in it. that is a good time to put in some more penetrating oil.
(all said with not much specific experience!) You will have more patience than me, but don't wait until it snows. 
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what size is the head stud threads etc for 24 stud v8 merc | RichardT10829 | The Carrier Forum | 11 | 06-12-11 20:14 |
| Morris Commercial CS8 / C4 | Richard Farrant | The Softskin Forum | 0 | 04-12-05 13:06 |
| Morris Commercial C4 | Rolf S. Ask | The Softskin Forum | 16 | 17-11-04 00:06 |
| Frozen Stud Removal – Aircraft Dye Penetrant | Bob Moseley (RIP) | The Restoration Forum | 4 | 28-03-03 06:11 |
| Engine stud removal | Mike K | The Restoration Forum | 3 | 01-03-03 22:36 |
Threaded Mode