An Introduction: Chris Collins and Morris Tilly Project

[jack neville]

Chris intends to tow a trailer (read custom tear drop Tilly camper yet to be designed and built) so a tow bar is required. There is not a lot to attach a tow bar to on the chassis of a Tilly so in repairing the rear box section of the floor (which welds between the ends of the chassis rails) I decided to reinforce that area.
A piece of 3mm sheet was first folded to replace the rusted box section I had cut out. Another 3mm piece was folded to add inside.
I will weld nuts inside this section to pick up and support the tow bar. There is two holes with crush tubes about half a metre from the chassis rail ends that can be utilised to fix the front end of the tow bar. This will be adequate support for the tow bar which I can fabricate once all this is in place.