|
|
#19
30-07-17, 06:33
|
|||
|
|||
The Cdn Army had those two zerk fittings removed as they did not properly grease the rear wheel bearings. As well, if you over-do pumping grease into there, it has to go somewhere. I suppose putting grease into there is better than nothing, but ideally you remove the axles, clean and inspect the bearings, I go with new inner and outer axle seals (since they are fairly cheap) and set the axle preload/endplay at the same time. Then you can drive with confidence. But it is a big job for a novice.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: M38a1 cdn 2 1967 | tristan L. | For Sale Or Wanted | 14 | 21-09-16 13:31 |
| 1967 m38a1 dash | Jeff Vandermey | Auction and Classified Ad Site Heads Up | 4 | 03-11-15 09:51 |
| Sold: 1967 m38a1 | oldlithgow | For Sale Or Wanted | 4 | 22-09-15 06:03 |
| For Sale 1967 M38A1 CDN2 | Casey B | For Sale Or Wanted | 1 | 03-10-11 19:34 |
| M38A2 Cdn 1967 For Sale | Wpns 421 | For Sale Or Wanted | 0 | 12-07-11 04:27 |
Threaded Mode