|
|
#16
27-01-18, 17:53
|
|||
|
|||
Thank you
Andrew,
Thank you ! The dimensions are different than the stiffeners used in the lower cabs. I shudder at the thought of trying to gather the required information to restore an old vehicle such as the Lynx without the support of people such as yourself, the MLU forum, and the internet. Could I trouble you for one more set of measurements? The reinforcing patch that goes over the latch area? Thanks again, Peter 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 08:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 13:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |
Threaded Mode