|
|
#3
18-09-18, 10:34
|
|||
|
|||
Hi Jaques
These tie down loops have a half inch shank (1/2 UNC) and they have been specified for a sedan that weighs 1700 lb unloaded. If they are a Ford part, it is possible they could have been used on different Ford wartime builds, maybe even the '42 staff cars built in Ontario? Perhaps your frames 7/16" hole provision is a bit lightweight for a heavier 4WD? Like you say, it is a mystery. James
__________________
Own a 1942 Ford 2GA 73C Ford Sedan 6 cylinder Staff Car under restoration 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tears in your eyes?? You will have after reading this. | lynx42 | The Sergeants' Mess | 0 | 03-12-12 02:25 |
| Gentlemen. Feast your eyes!!! | Jack Hazeldine | The Carrier Forum | 5 | 06-08-12 22:21 |
| T-16 Rear Lift EYES Needed | khern2365 | The Carrier Forum | 0 | 02-01-11 02:53 |
| CMP tow eyes | sapper740 | The Restoration Forum | 20 | 14-06-06 02:57 |
| Lifting Eyes | Nigel Watson | The Carrier Forum | 4 | 03-05-05 06:55 |
Threaded Mode