|
|
#10
20-02-19, 05:59
|
||||
|
||||
Seal sizes for transfer case
So I just pulled the seals out of my transfer case and they all appear to be the same size. One was so bad that the oil could have been drained out the gap instead of the drain hole.....
Two of them have a paper gasket behind the plate and they are in bad shape. The input one has a steel gasket in place and no paper ones. Any ideas on sourcing these paper gaskets? The steel one looks fine although I am unsure if it would work without a paper one as well? If it was aluminum or copper I could see it being a crush type but it is definitely steel (has rust). Thoughts on the gaskets? Should I just try to cut my own?
__________________
Many projects..... Complete- Ford F8 truck Complete-1956 Mk 2/3 Ferret Complete- Bofors 40mm on carriage Complete Reproduction- Vickers, Model 1937 Tank Waiting restoration- 1950 Cambridge carrier, Ford CMP Water truck, 1943 Universal carrier, 1945 Dodge APT truck, Canadian C3 Howitzer, several parts vehicles and a few ideas..... 
|
|
|
Threaded Mode