Armour Dreams

[Jonathan Moore]

I have been playing with my nuts, so to speak. I made the thread on the end of the idler shaft to fit the nuts from a Land Rover stub axle, using a genuine land Rover nut, thinking that it would save me some time. I then ordered four nuts from a british parts supplier and only one would fit. So I ordered another ten, my thinking was that I would have the four that I needed and some spare for my land Rovers, these things are always worth having about. Only one of the ten would fit, either the original stub axle or my shaft. It's not worth sending them back, so I decided to clean the threads out. Trying to centralise the nuts in the four jaw chuck using a DTI on the thread is a no go, so I put the nut in the four jaw, threaded the shaft in as far as it would go, about 1 1/2 threads and then, with a centre in the other end of the shaft, I clocked the shaft. Lining the threads up with the threading tip was a bit of a fiddly job but the result is fourteen nuts that I can use.