|
|
#11
10-04-19, 14:57
|
|||
|
|||
Jordan,
Regarding your question about the bearing fit on the splined shaft. The bearing should be a press fit on the shaft. Same as the corresponding cup should fit tight in the bore. You want the rolling elements of the bearing to do all the work, not the inner or outer race spinning on the rotating parts. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode