|
|
#11
05-05-19, 05:29
|
||||
|
||||
Thanks Bob. It’s gett there. For fuel and vacuum lines I simply copied the ones that were on the original wartime engine. However I went to test fit the throttle linkage and I ran into a snag. The lines are directly in the path of the horizontal rod from the linkage. So back to the drawing board for some tweaking.
Today I was off to visit a friend and see a new project he recently picked up. I was able to borrow a number of the splash guards and an inner radiator shroud.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 03:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 03-04-15 00:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 23:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 07:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 04:42 |
Threaded Mode