#1
|
||||
|
||||
Unknown sheet metal part
I’m trying to ID this sheet metal part. It came with a Cab13 C15a that a friend recently picked up. We can’t figure out where it goes. It may not even be CMP.
It is 22” long, 2” high and 5-1/2” wide. Along the one edge there is staple holes. Any help would be much appreciated.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Modifying Princess Auto sheet metal brake | Jordan Baker | The Restoration Forum | 5 | 11-12-16 18:23 |
How to make exquisite sheet metal pieces | maple_leaf_eh | The Restoration Forum | 4 | 27-07-12 14:09 |
Calling sheet metal Guru Barry Churcher... | Bob Carriere | The Restoration Forum | 6 | 08-03-09 00:00 |
Pattern 12 Sheet Metal | Phil Waterman | The Restoration Forum | 1 | 27-02-05 00:04 |
Unknown part | Jordan Baker | The Carrier Forum | 2 | 10-01-05 05:05 |