Winch Data Plate

[Jacques Reed]

Originally Posted by Ganmain Tony

In that case, I wonder is you might be able to photograph it at a flatter angle and post it here?.

Our mutual friend and MLU'er Jacques Reed (I think) has the ability to make reproductions if the picture is of sufficient quality.

Jacques... I just threw you under the bus!!

Hi Tony,

And I just thought it was a speed hump!

All joking aside there are two options: Decaled plate or laser engraving. I can do the artwork but have to farm out the laser engraving.

Happy to do the artwork and make a decal, or pass it on to the laser engraver. Scanned on a flatbed scanner at about 600dpi is best to reduce distortions, and for good resolution, and with the actual dimensions to ensure correct registry. I am sure the mounting holes spacing would be nice round Imperial measurements.

Put it up here and I will have a go.

Cheers,