SHIELDS, Coil, 2.5-inch x 4.5-inch, No. C1A ZA/CAN 4238
This pair of shields cover the upper pair of coils (from left to right L19A and L17A) in the Coil Assemblies, IF, and differ from their lower counterparts only by the presence of small, metal sleeved holes in the end of them to allow the Grid Cap Clip leads from the coils inside to pass through.
Just enough of a difference to get an ‘A’ added to the end of their ID and a new ZA/CAN Number.
With regards to removing these shields, you have no choice; the Grid Cap Clips must be unsoldered from the ends of the leads. These leads are not long enough to allow the shields to slide up far enough on them to access their solder terminals inside the Coil Assemblies.
Once the Grid Cap Clips are removed and the mounting hardware removed behind the chassis wall, the shields lift off easily.
David
|
11-07-21, 21:05
Similar Threads
Threaded Mode