|
|
#3
09-10-21, 02:31
|
|||
|
|||
Hi David. I was not saying it was 3/4 ton Dodge, just that the spline is the same. The Dodge one has the ball on the opposite side and is a one piece forging. This one has a ball stud that is retained by a swage (similar to a rivet)
The offset (straight edge on the back) is approx. 105mm (center of ball to straight edge) The ball dia 0.980". Effective length (C to C) 6 7/8". Also, it does have four equally spaced master splines, as per the 3/4 ton Dodge. Could it be M37? On one side it has "1035 W W" and on the other "265469 M3" Chrysler? GM?
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
|
Threaded Mode