Wireless Set No. 52 Canadian - Project

[David Dunlop]

The next thing I have to do on the Spare Parts Case is carefully sand down the lumpy runs of tan yellow paint on the inside lip of the case and lid. Fortunately, there are not many of them, I will also go over the edges of the lips, where necessary, to cover up the light green paint that found its way there.

It is important to get this done now and have enough time for the touch up paint work to hard cure as when it comes time to repaint the case, it is these two surfaces that the case will be resting on during painting and cure drying. So the sooner the work gets done, the better.

One other discovery at this point. I had assumed the KimPak padding in the Spare Parts Case was glued in place. However, the padding is in such great shape in this particular case I can easily see the small wire staples that were used about a half inch in around the perimeter of the padding to hold it in place.


David