|
|
#31
14-06-24, 18:56
|
||||
|
||||
I’m glad I fully took apart the transmission as two bearings needed replacement. On closer inspection both had a bit of a “hang up” when rotating. I was able to find a bit of rust on the bearing inner race surface of one of the bearings. Two bearings have been ordered from a supplier. Hopefully I’ll have them in a few weeks.
Lastly a new output shaft seal was added. This should give many years of good service.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "Falaise" Otter number 2 | Bruce Parker (RIP) | The Armour Forum | 42 | 05-12-22 23:15 |
| Otter air cleaner?? | BCA | The Armour Forum | 0 | 11-10-15 00:39 |
| GMC Fox MK I and Otter MK I | lssah2025 | The Armour Forum | 2 | 30-07-13 04:49 |
| GMC Otter MK I | lssah2025 | The Armour Forum | 11 | 25-03-13 20:54 |
| GM Otter car | Libor Zachoval | The Softskin Forum | 3 | 05-03-12 16:09 |
Threaded Mode