Wireless Set No. 52 Canadian - Project

[David Dunlop]

With required holiday work around the house under control now, I have been able to get a little more work done on the restoration of the case for the Coil, Aerial Tuning No. 2 A.

I have been able to strip the old paint off the two Brass Mounting Plates used to secure the Coil to the top of the Carriers No. 4.

The attached photos show the original state of the left plate, after it was stripped and of both the left and right plates after stripping. Both plates still need to be cleaned further with a small brass wire wheel, as well as the hardware for both plates. This work was on hold because I only had one brass wire wheel for my Dremel available, and it was worn out. I have worn out six of these wheels now with this project and at a local cost of just under $13.00 Canadian a pair, that novelty was wearing off. I then discovered I could order 15 such wheel from Amazon for just under $18.00 Canadian and went that route. The last photo shows what was left of my remaining brass wire wheel, along with the new ones.



David