WTB/K wire-pull armored veh CO2 ext. system

[daninnm]

I am driving my M18 Hellcat to aprades and at reenactments and the CO2 extinguiosher sysem is not present - very dangerous because it would be hard standing over a raging gasoline fire in the engine comparment trying to discharge a CO2 extinguisher on fire going on down there. I prefer not to burn up or have my Hellcat burn up. Though I haven't had fires; I know of one owner than had two - fortunately, their rear engine compartment door was open at the time.
I HAVE THE TWO LARGE CO2 BOTTLES
I NEED:
the two wire-connected valves that screw on top of the bottles
the "tee" connector you can see in the attached picture
any of the other plumbing around the bottles valves.

I have the discharge cones in the vehcile and all other plumbing including the wire tee handles you pull to discharge each bottle inside or outside the Hellcat.

This system was used on many armored vehicles. The picture attaches is the exact system in a G122 Staghound . It was used in M18s, Shermans, Pershings (in fact the stock number is a Pershing number) and others. HELP........will pay nicely for the aprts to be safe!
Dan in NM
505-269-2056