|
|
#1
13-11-07, 10:26
|
||||
|
||||
Ford dynamo
I am seeking info on a Ford dynamo fitted to a V8. It is one British engine fitted to a Fordson WOT, normally a Lucas item and I am not fmiliar with the Ford one and cannot find anything on them. My question is, which are the correct terminals, in relation to the attached photo. The wiring was not connected so I want to get it correct first time as it is being rewired.
From the CAV control board, there are the two wires, F (Field) and D+ (Dynamo positive). The dynamo has a cap on top with terminal at pulley end and brush end, I need to know which is which.
__________________
Richard 1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2 Member of MVT, IMPS, MVG of NSW, KVE and AMVCS KVE President & KVE News Editor 
|
|
|
Threaded Mode