|
|
|
|
#1
01-10-08, 14:20
|
|||
|
|||
Well done John.
You should be able to get silver solder with a melting temp way lower than Brass. How are you going to fix the hinges? Does the extrusion have the hollow section for the joining piece? Rich
__________________
C60S Austin Champ x 2 Humber 1 Ton & Trailer 
|
|
#2
02-10-08, 10:55
|
|||
|
|||
|
Have used the same brass in my 13 cab, obtained from Peter Jackson, he,s up the central coast NSW now . strenthen the corners with brass angle inside on the bottom soldered in, outside on the top screwed to the hinge. Either fit new glass ( $60 a side) or fit wider "t" rubber. took one to corowa this year for K W. to check out. its easy to work with.
__________________
macca C15 C15A
|
|
#3
02-10-08, 11:05
|
|||
|
|||
|
Was just about to suggest the same person. His website has pictures of the profile on it . Have not used it ourselves, but had started looking into it.
http://www.jackson-s.com/olderaservices/ Ben
__________________
1942 Chev C-60S Pacific Marine Fire Engine 1962 Series II Landrover Ambulance
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
