|
|
|
|
#1
14-11-08, 06:08
|
|||
|
|||
That would do...
...but the 'official' way was to remove that base and install one that was made from two channels with flat plates welded to either end. The wireless set fastened to this 'adapter' by four shock mounts with the supply unit on top like this:
|
|
#2
14-11-08, 16:11
|
||||
|
||||
|
Some USA Vehicle Mountings
Shot below is how the No 19 set was sometimes mounted in USA armoured vehicles that used British equipment. Parts of this setup originated in a WWII M4 installation kit. Not sure what other options the Sherman tanks had with earlier wireless sets if they used them.
__________________
David Gordon - MVPA # 15292 '41 Willys MB British Airborne Jeep '42 Excelsior Welbike Mark I '43 BSA Folding Military Bicycle '44 Orme-Evans Airborne Trailer No. 1 Mk. II '44 Airborne 100-Gallon Water Bowser Trailer '44 Jowett Cars 4.2-Inch Towed Mortar '44 Daimler Scout Car Mark II '45 Studebaker M29C Weasel
|
|
#3
16-11-08, 20:29
|
|||
|
|||
|
Bruce Mac.
I would love to see the details including the measuements of each section of the aeriel, and the "rain hat"
This is my last visit to the forum until I can get set up at our new residence, so it may be a week or two before I can respond. Thanks, both Bruces, and others.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions....
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
