Valve removing bar

Mike K · #1 20-01-09, 23:45

tony

There was a nifty aftermarket device available for removing stuck valve guides on those Ford motors .. Its a length of rod shaped to fit around the valve head .. the lower end is hollowed to fit around the valve stem .. you carefully insert the tool down into the port, around the valve , then hit the tool with a hammer , the split guides will sometimes become stuck and the normal lever tool wont move them.This tool moves them every time .

Ive got one of the special tools .. Its loaned to a friend .
Mike

Tony Smith · #2 21-01-09, 02:50

Yup, I got one too! From Flatattack, it's the 2nd item down on the left in the pic above. $45 new.

ron · #3 22-01-09, 11:04

Hi Tony,
Many thanks for the information, I will contact him in the morning,
Regards Ron

ron · #4 22-01-09, 11:06

Hi Mike,
Thanks for the reply, I will buy a set tomorrow thanks for your help.
Regards Ron

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode