![]() |
|
#1
|
||||
|
||||
![]()
try this
![]()
__________________
Have a good one ![]() Andrew Custodian of the "Rare and Rusty" ![]() |
#2
|
|||
|
|||
![]()
Thanks a million Andrew! That will certainly take out the guesswork on the cover! May have to stretch the dimensions on the rear and left side a little to fit the new hole, but not by much.
Thanks again! David |
#3
|
|||
|
|||
![]()
Looks like the same would fit my cab 11 C15a...... I made a copy of your sketch and will compare to my two rusted hulks....... your sketch should save us some fiddling around.....
Some CMP users have used a square of grey foam to serve as a gasket for the gear shift lever..... why was there never anything avaialble for the various CMP.... even a later service retro fit booth of some sort...? Boob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
#4
|
||||
|
||||
![]()
No worries
Hope it helps It seems to fit all the cab 12 models i have so would imagine it should fit cab11 models also ?
__________________
Have a good one ![]() Andrew Custodian of the "Rare and Rusty" ![]() |
#5
|
|||
|
|||
![]() Quote:
I've found evidence of piece of 1/2 to 3/4 inch think black rubber foam under the steel cover and around the shift tower on two of my trucks. Will have to check the photos to see if I have a picture. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com |
![]() |
Thread Tools | |
Display Modes | |
|
|