|
|
#28
13-05-09, 21:10
|
||||
|
||||
right order the metal hl tiger sprockets and cut the outer ring off it make the correct shaped boss as per the carrier, bond / pin the ring onto the boss and voila.
if the diameter is not correct then you will struggle as the pitch of the teeth will be matched to the segments on the track, and a bit of jiggery pokery will be needed, you may end up having to cast your own rings for it. if push comes to shove, use the tiger rings make a center for them and use full length sand guards on the carrier  Rich
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode