|
|
|
|
#1
10-04-10, 19:22
|
|||
|
|||
Is this a plotting board holder?
Gents
I was out at the museum yesterday and took some measurements of my CGT ceiling just above driver. What was the purpose of the holder, the box at the window and the 2 -1/4 NC stud mounts? The other question is there is a wooden block in the middle, it should also have a spring clip which I haven't made yet? I also added 2 pictures of the Newtonville CGT in 2004. Walde 
|
|
#2
22-04-16, 09:04
|
|||
|
|||
|
Table and tripod
Opening an old thread after again...
Does anybody have pictures of the tripod and plotting board mounted inside the Gun Tractor? Thank you, Frankie Last edited by Frantisek Nachlinger; 22-04-16 at 09:06. Reason: grammar
|
|
#3
22-04-16, 13:26
|
|||
|
|||
|
When were cab 13 CGTs introduced?
I have asked before but I think my post was to involved.
Regards Howard
|
|
#4
23-04-16, 00:27
|
||||
|
||||
|
Where these boards in both cab12 and 13?
__________________
1941 Chevrolet, Cab 12 CGT, 7A2 body 1944 Ariel W/NG 1944 Scammell Pioneer SV/2S x 2 1955 Austin Champ, 04BF45 1946 Chevrolet 5400 COE, Civilian
|
|
#5
16-05-16, 11:10
|
|||
|
|||
|
cab 12 board holders
Quote:
|
|
#6
16-05-16, 17:33
|
||||
|
||||
|
Quote:
__________________
1941 Chevrolet, Cab 12 CGT, 7A2 body 1944 Ariel W/NG 1944 Scammell Pioneer SV/2S x 2 1955 Austin Champ, 04BF45 1946 Chevrolet 5400 COE, Civilian
|
|
#7
16-05-16, 20:44
|
|||
|
|||
|
Photos
I will ask him to send me few.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
