![]() |
|
|
|
#1
|
|||
|
|||
|
Without a photo, this is pure speculation. My money says it is a overdrive, which could require the relocation of the park brake handle. But the photos will say it all. You mentioned in another thread that this jeep had a crash pad installed. Sounds like it had a few civilian improvements, which makes me lean towards the overdrive vice a PTO.
|
|
#2
|
|||
|
|||
|
The winch and PTO - of course. I didn't think of the winch because it's one of the few things missing. And the extinguisher bracket is, in fact, on the dash so SMG bracket it is.
WRT the crash pad, I have a theory that it was actually a CF addition, albeit not one approved by Ottawa. As I also posted in a different thread, the windshield frame on this truck is light blue underneath the green and black camoflage. I suspect that something happened to the original windshield frame, and some enterprising V-tech got a CJ5 frame from the scrap yard to replace it. The pad has also been painted green (it's black underneath). Many thanks for the answers - pics are attached below for 2nd and 3rd opinions...
__________________
Mike Baker Comox, BC |
|
#3
|
|||
|
|||
|
I have never seen a PTO control mounted in the spot you show. Normally they are through the small plate that is just before the location of your park brake handle.
The winch brackets on the front of the vehicle are not stock either. And since there is green paint over your PTO lever, the vehicle has been painted since it's entry into civilian life. My money says the crash pad and windshield were add ons in it's civilian life. There were windshield frames available in the system right until disposal of the fleet, made by Mil-Quip (formerly Automobiles Rene Gagnon) |
|
#4
|
|||
|
|||
|
Quote:
__________________
Mike Baker Comox, BC |
|
#5
|
|||
|
|||
|
When you get a chance, show us what the extra lever attaches to. It should be a gearbox of some form on the back of the transfer case.
|
|
#6
|
||||
|
||||
|
One other point that supports the PTO being put on post auction is that your ECC is for a regular 38A1 and not the "With Winch" version.
Scotty |
|
#7
|
|||
|
|||
|
Got an opportunity to spend some time under the truck tonight, and discovered that the extra shifter is attached to (...drum roll...) a Warn Overdrive. Could also explain the reversed e-brake handle.
Pic attached. - in the first you can see the overdrive level behind those for the transfer case. In the 2nd is the overdrive itself, with the rusty rod for the e-brake in the foreground. The 3rd is an overhead shot of the e-brake handle.
__________________
Mike Baker Comox, BC |
![]() |
| Thread Tools | |
| Display Modes | |
|
|