|
|
|
|
#1
22-08-10, 13:50
|
||||
|
||||
Did consider it but I havent got machinery to do it and the engineering workshops around here charge a absolute fortune .
There are a few casting places in the state that do a good job .Look more original also . I am waiting for a couple of quotes to get a idea of price .Making the moulds initially is the most expensive part apparently so the more you get made the better the price per unit
__________________
Have a good one  Andrew Custodian of the "Rare and Rusty" 
|
|
#2
22-08-10, 17:55
|
|||
|
|||
|
Wheel adapters
Hi, Look at this thread (#143). David DeWeese had some made from aluminium. If he has an engineering drawing that he could send to you it would lower your cost considerably.
http://orbit.dnsrouter.com/~mlu/foru...deweese&page=5 Paul
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
