|
|
#8
29-09-10, 19:31
|
||||
|
||||
Hi Tony,
Did you use any sealer on the face between shaft and hub? I know silicone is popular now, but I avoid it on places like this because it tends to go off before you get the flange up tight and you end up with a thick membrane of silicone and this would allow the two parts to fret and shear the studs. Just a thought anyway. regards, Richard
__________________
Richard 1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2 Member of MVT, IMPS, MVG of NSW, KVE and AMVCS KVE President & KVE News Editor 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode