WANTED: UC No2MkII* speedo driven gear

[Gunner]

Hi Marc:

Try Brian Asbury.

Cheers! Mike

[Marc van Aalderen]

Originally Posted by Gunner

Hi Marc:

Try Brian Asbury.

Cheers! Mike

Hi Mike,

Thank you for a possible contact. How do I reach Brian? Is he a MLU member?
I do not know him.

Cheers,
Marc

[RichardT10829]

Marc are you refering to the brass adapter which screws into the hole on the cast peice that dirk showed you ? if so if you promise to give me it back i will lend you mine as a pattern to get one turned on a lathe...would not be a hard job for a capable person ?

[BCA]

Hi Marc,
If you mean the angle drive gear that clamps onto the speedometer then I have NOS ones in stock. Send me a PM.
This a cast fitting that the speedometer cable threads onto so you can attach the speedo cable to the speedometer. There must be properly greased and turn freely or the speedometer cable flexible shaft will break. This angle drive for Mk1 and M11 speedometers is diffrent than the T16 Carrier angle drive.
Brian

[Lynn Eades]

They are refering to the other (gearbox) end. I will post component pictures in the next 48 hrs.

[RichardT10829]

Marc this is the bit i was refering too

listed as part no CTL 2216 or is it the spindle from inside it which is listed as CTL 2510 B2

Richie

[Lynn Eades]

Heres the pics. Dirk your housing is interesting. It appears to have a seal in it. I havent seen one like that. My one has a "W" cast in it. Is that Windsor?
The speedo drive bits have all the faults.

[Marc van Aalderen]

Originally Posted by BCA

Hi Marc,
If you mean the angle drive gear that clamps onto the speedometer then I have NOS ones in stock. Send me a PM.
This a cast fitting that the speedometer cable threads onto so you can attach the speedo cable to the speedometer. There must be properly greased and turn freely or the speedometer cable flexible shaft will break. This angle drive for Mk1 and M11 speedometers is diffrent than the T16 Carrier angle drive.
Brian

Hi Brian,

I didn't know that that is something I'm also missing. It does make sense as the space in the Dash is very limited so no room for the speedo cable to make a big radius bend. PM sent. Thank you.

Cheers, Marc

[Marc van Aalderen]

Hi Lynn and Richard,

You were both looking at the correct parts. I tried to find a picture of these parts in both workshop manual and Mk1* parts catalogue but there is absolutely nothing in either book. Then I looked in the later parts catalogue for Mk1* AND MkII*. This uses the same plate as the Mk1* parts catalogue but with the two items I need added! It shows the gear CTL2216 and housing CTL 2510 B2. So Richard, you were right there. !! Lynn's left picture says it all, they probably fail often...

Lynn or Richard, if nobody has NOS or used good parts for me can I borrow one of each part from either of you to have them made? I will off course return them after reproducing them.

BTW, Lynn the seal is also shown. Part number C01UC105387

Cheers,
Marc

[RichardT10829]

yes no problems buddy just keep me posted.