Thanks for the input guys. Its good sound advice and I will take another look at the task to consider whether I can achive my goals without sandblasting twice. I am not too bothered about the new track covers in sides of the hull and over the rear axle as the metal is not badly corroded here and will clean up very well. Its really the floor. The bulkhead behind the driver is corroded in places right where it joins the floor, and the inboard brackets that support the axle brackets in the front need remanufacturing and welding to the floor, plus umpteen brackets and fixings on the floor. I am just concerned that I will not get the metal on these areas clean enough to weld effectively. Its certainly worth a try though as it will cost a lot less than sandblasting. I keep doing jobs on this project and convincing myself that I have done the worst job on the Carrier! Well today, I am sure the removal of the axles housings was the worst so far. As long as they go back in ok, then I feel I have broken the projects back. Loads to do , but I think I am past the worse, although not half way. I have attached a photo of the floor once more. Will post more soon.
|
12-12-10, 23:29
Threaded Mode