|
|
|
|
#1
10-07-11, 06:14
|
||||
|
||||
Switches And Switch Plates
Hi Scott - looking at your images of the switch plates I am not sure whether they are correct. You need to remove them to see if my attached image fits.
The switches you are asking about, I am on my second box of fifty. Again look at my switch image where you can see five out of the six are Off/On switches whereas the Gas Switch is an On/On switch that took me over a year to source. There are plenty of On/On Bat Handle toggle switches but not Ball Handle. I have also replicated the small switch plates. I have a couple of complete sets left but then I am out of the On/On switch until I can find some more. On the other hand if you require the large switch plates, I have provisions for those as well. The only difference with the old and new switches is that the On/Off toggle does not stop in the centre. It rests above and below centre respectively. Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com 
|
|
#2
10-07-11, 06:36
|
||||
|
||||
|
OK but
A common problem with sender units is: the rotating shaft has to make a earth connection to the sender units body .. Sometimes that shaft doesn't touch the body cleanly ..it's a intermittent connection as it rotates . Make sure you are touching the actual body of the sender with the probe , not just the shaft itself . If you are touching just the shaft, then your getting misleading results
AC= Albert Champion , the modern spark plug inverntor .... I think I am correct.
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad
|
|
#4
10-07-11, 12:27
|
||||
|
||||
|
Switch Plate
Hi Robert - well here is something new to me. I have never seen this configuration of switch plate. I would love to get my hands on one of these to see if I can replicate it.
Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com
|
|
#5
10-07-11, 12:46
|
||||
|
||||
|
Scott
PM sent.
Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com
|
|
#6
10-07-11, 13:55
|
||||
|
||||
|
Memory boost for Bob Moseley
Bob check out the thread Robert Pearce starts to restore post #91 to #94.
The plate is about 1/16" and the lettering embosed from behind. I realy hope to have the blitz at Corowa 2012. 
__________________
Robert Pearce.
|
|
#7
11-07-11, 10:18
|
||||
|
||||
|
Switch Plate
Hi Robert - I remember it now but never did anything further with it. What I need is to see, touch and smell this plate to see if it feasible to replicate it. Any offers of a loan?
Bob
__________________
Chevrolet Blitz Half-Track Replica - Finished and Running Ford F15 - unrestored Ford F15A X 2 - unrestored Website owner - salesmanbob.com
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
