|
|
#5
28-09-11, 00:43
|
||||
|
||||
lynn, box is tight on the bracket and I put in a new self aligning bearing on the bottom, so it is just a matter of selecting the required shim thickness to eliminate the worm shaft end float when the four bolt seal housing is tightened up?. Not sure if the Canadian ford manual has info on setting up the correct float?. Seems to be ok and not squeaking at the moment but is a little tight so will perhaps add in a thou shim when i change the seal.
kev.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode