|
|
|
|
#1
04-02-12, 03:34
|
|||
|
|||
Let's try again...
See if this works..
...... that's better
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada 
|
|
#2
04-02-12, 09:22
|
|||
|
|||
|
G/box
it might fit but it would be like buying the wife a new dress, the housing fits BUT then the tailshaft, diff housing could make the exercise very expensive, just like new shoes, hand bag and hair. must have one around here some where will look in the 37 chev wreck for you this w/end .
__________________
macca C15 C15A
|
|
#3
04-02-12, 23:17
|
||||
|
||||
|
Quote:
__________________
Have a good one Andrew Custodian of the "Rare and Rusty" 
|
|
#5
05-02-12, 00:57
|
|||
|
|||
|
Using up what was in the system
Hi Bob
I've seen the same thing early transmissions have the entire speedo machining on the end of the transmission and the internal gear. Later have neither the machining, bosses are there but not drilled and tapped. Also there is no gear on the rear shaft. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
