|
|
|
|
#1
26-02-12, 23:41
|
|||
|
|||
Small tube is the pin
Hi Jordan
Below is a picture of my gas peddle from my HUP, the pin is actually a piece of tubing which is slightly flared at the ends to hold it in place. Let me know if you need a different photo angle. Cheers Phil
__________________
Phil Waterman `41 C60L Pattern 12 `42 C60S Radio Pattern 13 `45 HUP http://canadianmilitarypattern.com/ New e-mail Philip@canadianmilitarypattern.com 
|
|
#2
26-02-12, 23:43
|
||||
|
||||
|
That's exaclty what I needed to know. What I thought were bushings must have been what was left of the tubing and it had rusted away on the inside.
Thanks
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#3
27-02-12, 17:23
|
|||
|
|||
|
Perhaps.....
.... a short piece of stainless steel brake line suitably flared...... should last longer than the gas pedal......
Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
