axle cover brackets

[Jordan Baker]

Im not sure what measurments you are looking for. That rear deck is complete with all of the brackets/clips that were on a standard Mk1* Carrier. There is an approx 3/4" hole beside the far clip. That is for the conduit fitting to pass through. It holds the wiring for the tail light fitted to the rear plate.

[roy206]

this is not our deck.
our deck only have the 2 exhaust covers,and on the right side against the rear armour plate a little bracket in the corner.
what i need is the measurements from the 2 brackets and the bracket for the lifting jack,also the the right position were fitting them.

roy

[kevin powles]

Hi, Here is a picture drawn of the two brackets for retaining the jack, also the centre boys tripod/monopod bracket, also details of the rear battery box rod support strip bracket and ration tray strap retaining stud. The jack brakets are easy to make from one piece folded steel. attached are the ones i made. I have since come by some original brackets but they are no different to these. Have not got dimensions of were they are located on the rear deck at the moment.

kev.

[roy206]

kevin very helpfull pics
and i like the picture draawn very much.
thanks for it.

only the big bracket for the lifting jack and i have everything i need.

[roy206]

the little bracket in the right front corner is for the starting handle and goes from the left too the rear all over the deck behind the jack brackets?

[kevin powles]

Hi, I have a detailed drawing for the jack block holder, i will post it in the next 3 days, I not sure what you ment in the post previous to this one??.

kev.

[roy206]

on the rear fender right side is a little bracket mounted against the rear armour plate,(on the picture it is damaged)