Help needed with details of the steel work behind and under front armour

[Lynn Eades]

Thanks for that, Now I would like to see from underneath looking up.

Have you any pics of the other side?

What did you do your countersinking with?

Pic = a few more rivets

[RichardT10829]

will quickly run out to the garage now and photograph before work...two tics

[RichardT10829]

right. here are some pics from the underside hope they are ok




the countersink cutter i used was a Maykestag cobalt cutter 16.5 x 90 i use a slow speed drill and drill into the plate to create an OD of 15 - 16mm then with my setting snap i know i need an 11mm tail on the rivet (after its come through the armour that is)




http://www.ebay.co.uk/itm/16-5mm-Cob...ht_1797wt_1270

hope this helps matey

Richie

[Michael R.]

Lynn, you wrote (paraphrased):

I wish to see how the angle iron going forward meets the steel work at the bottom of the front armour.
The bolt in the first picture would hold the front guard on.
The second picture shows (arrow) where the detail would be that I require. The hole the headlight wiring goes through should help you.


Here are your two images along with what I hope is the information you have requested. You will see the holes open where the mounting bolts that hold the Gunner side fender are currently removed.

[Michael R.]

More pics of that corner and below:

[Lynn Eades]

Thank you very much for your help. That is exactly what I was after.