MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Carrier Forum

Notices

Reply
 
Thread Tools Display Modes
  #1  
Old 30-10-12, 19:41
George McKenzie George McKenzie is offline
Registered User
 
Join Date: Sep 2006
Location: Northern Alberta CA
Posts: 451
Default MK1 Speedometer

My gage has been cracked for probably 40 years . The question now is How much radiation is left and is the whole gage contaminated .Can it be redone up with a new dial and glass without hurting someone .If this can't bedone then is it even safe to remove it without some protective gear .
__________________
George is hooked on OD
5 window DT969
8 ton Fruehauf trailer
M2A1Halftrack ,CMP #11 F15A1 #13 F15A1
RAF Fordson Tractor, 42 WLC HD
No.2MK11 CT267514 center CB24713 bottom hull25701 ,No.2 MK2 parts
MK1 10128 ,(2) MK1 ,Parts Hull9305 .Hull 10407
Hull plate # 7250 all have walk plate on back steps
1917 Patent modle amphibious army tank
Reply With Quote
  #2  
Old 30-10-12, 20:27
RichardT10829's Avatar
RichardT10829 RichardT10829 is offline
Richard Harrison
 
Join Date: Nov 2008
Location: Cullercoats Newcastle Upon Tyne United Kingdom
Posts: 3,068
Default

the gauege will be thoroughly contaminated mate, the three small segments and needle tip are the bits that were luminised, you might be able to find somewhere to fit a dial face for you the problem is the dust being spread about... where is the gauge now ? if its in a box along with oher stuff i guarantee you everything in the box with the gauge will also be contaminated too..

in my humble opinion in your case i would at very least wear rubber gloves paper suit and respirator to handle the gauge with a broken glass face (not dismantle it) but the rubber only stops you getting particles on your hands and nothing more

the dial face could be done by someone i am sure but they would need a propper purpose built cabinet to put the dial into which was sealed and behind glass etc etc the dial face itself comes out with two screws the needle slides off..... thats easy.....just not easy to do without getting a dose or contaminating your workshop etc etc.
__________________
is mos redintegro

__5th Div___46th Div__
1942 Ford Universal Carrier No.3 MkI*
Lower Hull No. 10131
War Department CT54508 (SOLD)
1944 Ford Universal Carrier MkII* (under restoration).
1944 Morris C8 radio body (under restoration).

Last edited by RichardT10829; 30-10-12 at 20:34.
Reply With Quote
  #3  
Old 31-10-12, 18:22
George McKenzie George McKenzie is offline
Registered User
 
Join Date: Sep 2006
Location: Northern Alberta CA
Posts: 451
Default MK1 speedometer

The gage is still in the instrument panel on the carrier .I could duct tape the front to contain the dust and then remove it for disposal .I don't know how many guys have looked at this gage over the years . I have a box of gages for a halftrack ,wonder if they are the same problem too .
__________________
George is hooked on OD
5 window DT969
8 ton Fruehauf trailer
M2A1Halftrack ,CMP #11 F15A1 #13 F15A1
RAF Fordson Tractor, 42 WLC HD
No.2MK11 CT267514 center CB24713 bottom hull25701 ,No.2 MK2 parts
MK1 10128 ,(2) MK1 ,Parts Hull9305 .Hull 10407
Hull plate # 7250 all have walk plate on back steps
1917 Patent modle amphibious army tank
Reply With Quote
  #4  
Old 01-11-12, 09:42
RichardT10829's Avatar
RichardT10829 RichardT10829 is offline
Richard Harrison
 
Join Date: Nov 2008
Location: Cullercoats Newcastle Upon Tyne United Kingdom
Posts: 3,068
Default

George. wear a mask and gloves at the very least... possibly a good idea with the tape... do you have any spare glass fronts to replace the broken one out of curiosity?
__________________
is mos redintegro

__5th Div___46th Div__
1942 Ford Universal Carrier No.3 MkI*
Lower Hull No. 10131
War Department CT54508 (SOLD)
1944 Ford Universal Carrier MkII* (under restoration).
1944 Morris C8 radio body (under restoration).
Reply With Quote
  #5  
Old 01-11-12, 10:18
Lynn Eades Lynn Eades is offline
Bluebell
 
Join Date: May 2003
Location: Tauranga, New Zealand
Posts: 5,541
Default George

If you had a Mk I* speedo (see attached picture) I think they are completely safe. My guess is that they relied entirely on the panel light
I dont think there is any "luminous" stuff in there. Maybe the radium paint in the MkII* is the result of comlpaints about not being able to see the MkI* speedo at night.
With your MkII*, maybe it would be better to buy a nos one, and dispose of the old one. What ever you do, be careful.
Attached Images
File Type: jpg Dash panel speedo Mk1 Can.jpg (44.8 KB, 8 views)
__________________
Bluebell

Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
Reply With Quote
  #6  
Old 02-11-12, 19:51
George McKenzie George McKenzie is offline
Registered User
 
Join Date: Sep 2006
Location: Northern Alberta CA
Posts: 451
Default MK1 speedometer

I have a new speedometer for the MK2 but when Richard said he could make a MK1 out of the MK2 I thought great idea but then this problem showed up .Is there away of decontaminating the radium Water eg.? I have seen alot of carriers with broken gages and not once thought about radiation I would need the different dial and the glass for a MK1 tochange it
__________________
George is hooked on OD
5 window DT969
8 ton Fruehauf trailer
M2A1Halftrack ,CMP #11 F15A1 #13 F15A1
RAF Fordson Tractor, 42 WLC HD
No.2MK11 CT267514 center CB24713 bottom hull25701 ,No.2 MK2 parts
MK1 10128 ,(2) MK1 ,Parts Hull9305 .Hull 10407
Hull plate # 7250 all have walk plate on back steps
1917 Patent modle amphibious army tank
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 10:07.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016