Stuart headlamps

[Mrs Vampire]

I have a Stuart with original wiring and it has Hi Low beam . The circuit diagram also indicated Hi Lo beam.

I would attach the circuit but it would be too small to be of any use. happy to post either the original or my re CAD of the circuit.

from the manual

"screw stop, loosen the set screw that-locks the plunger to the rod.
125. Headlamps.-a. Description.-Eachfront fender of the vehicle mounts a service headlamp and blackout headlamp mounted on a bracket. The light switch on the instrument panel operates these lamps. The service headlamp uses a double contact bayonet base, 12-volt, 2-filament, 32-cp lamp. The blackout headlamp uses a single contact, 12-volt, bayonet-base, 3-cp lamp. Use the following procedures in replacing defective lamps or headlamps.
b. Replacernent.-(1) Lamps.-(a) Open battery switch.
(b)
Remove screw attaching lens frame to body of headlamps. Remove frame with lens.
(c)
Remove lamp.
(d)
Reverse the above procedure to install a new lamp.
(2)
Headlamps.-Due to the method used in mounting the head-lamps, if one headlamp is damaged, both headlamps mounted on that bracket are replaced.
(a)
Open battery switch. (
b)
Disconnect conduit coupling from bulkhead connector in armor plate and pull out three pronged plugs.
(c)
Remove three bolts and nuts attaching headlamp mounting bracket to fender. Remove headlamps with bracket and conduit.
(d)
Reverse the above procedure to install new headlamp assembly. Focus the' service headlamps.
c.
Service headlamp focusing.-After a suitable headlamp testing target has been set up, the correct light silhouette may be obtained by turning the focusing screw on the back of the headlamp. The correct position of the lamp may be obtained by adjusting the pivot and trunnion beneath the headlamp.
126. Taillamps.-a. Description.-Ataillamp is mounted.