|
|
|
|
#1
16-01-13, 21:50
|
|||
|
|||
I believe that some or all of the fittings you are looking for are common to the G-508 GMC. They may be closer than you think. Have you tried Rex Ward?
David
__________________
Hell no! I'm not that old! 
|
|
#2
17-01-13, 00:14
|
|||
|
|||
|
Hi again.
Jetcarrier is a firm that has specialized in shipping from USA to the nordic contries for private persons. Since many online stores in the usa do not ship overseas, you get as a registred customer a "private" adress in New Jersey for orders, and then the firm will ship it overseas to you. Shipping cost is quite decent.  They also ship cars, bikes, engines and so on. I have never used them before, but will give them a try for the flexible oil lines perhaps, and try to get the fittings here in norway. I will also check if parts for the GMW will do and see if these are more available. Thanks for the advice. If nothing works out I will try to get someone to pass it on for me  Svenn
|
|
#3
16-07-19, 15:54
|
||||
|
||||
|
Just wondering if anyone can give me the measurements for the brass block? Also the hard oil lines from the engine to the block. Are they 1/4” OD?
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#4
18-07-19, 13:28
|
||||
|
||||
|
Anyone? Just looking for the outside dimensions
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer
|
|
#5
15-02-22, 09:21
|
||||
|
||||
|
This one surfaced in Argentina
944FAB54-3EB8-440E-BE7E-613C361A6F0C.jpeg 756791EC-F203-41E8-B5D6-B5A5050F2AD8.jpeg
__________________
Regards, Hanno --------------------------
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
