|
|
#2
24-04-13, 02:47
|
||||
|
||||
Make sure you use low carbon rods or a Mig otherwise it will crack as soon as it gets a bit of stress
Frame should be cut at 45 degrees to maximise strength at a non-load bearing point Reinforcing plate should be added on the inside and welded on top and bottom edges (not on end of plates)End weld will cause a fatigue point and sometimes will crack at this point. Plate should extend well past connection point
__________________
Have a good one  Andrew Custodian of the "Rare and Rusty" 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode