|
|
|
|
#1
31-07-13, 01:40
|
|||
|
|||
The four pieces of wire is so that each side sits flat. If you run a single strand around the corner it bulges outand the boot doesn't sit tight.
It can be (and was done) done with a single long piece of wire, if you run some past each corner so as to form a loop that you can tighten by twisting at each corner. Does that make sense? A bit of practice will help.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carrier rear axle gears. | kevin powles | The Carrier Forum | 3 | 31-08-12 01:24 |
| carrier axle swap | 20387774 | The Carrier Forum | 11 | 26-04-12 17:32 |
| The early bellows air breather | Phill | The Carrier Forum | 2 | 04-06-10 12:02 |
| Sherman intake pipe bellows | Jesse Browning | For Sale Or Wanted | 0 | 10-05-10 01:39 |
| Carrier rear axle removal | kevin powles | The Carrier Forum | 5 | 18-02-10 19:51 |
Hybrid Mode
