![]() |
#6
|
||||
|
||||
![]()
Hi Mike and Lynn
Thank you for your good advice. I will not be rushing the job and will take your suggestions on board as I progress. As you guys have stated it might now be a good time to do those extra jobs. I think the water leak is relatively new as when I checked the oil about a month ago it was OK and I have only taken the old girl out for a 20 kilometre spin once since then. I didn't notice anything strange as the old girl was purring along OK and there was no tell tale smoke from the exhaust. The head had bolts and I was thinking of changing them to studs. The bolts still look OK and still have good threads, but I am not sure if they can be used again as I would not like to think I snapped one and had to go all through removing the head again and drilling out the shaft. So I think I will go slowly, and check everything as I go. Cheers Tony ![]()
__________________
Anthony (Tony) VAN RHODA. Strathalbyn. South Australia |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
water bag holder | oztankboy | The Softskin Forum | 25 | 21-02-19 02:52 |
Bedford MWC water | austin tilly | The Softskin Forum | 34 | 15-05-11 15:59 |
Water Trailer | acmva | For Sale Or Wanted | 0 | 14-07-10 18:07 |
FS: M1917 Water Cooled MG M1 Water Can | Steve Greenberg | For Sale Or Wanted | 0 | 17-11-09 17:34 |
Water | Rookie | The Sergeants' Mess | 9 | 30-03-08 01:02 |