|
|
|
|
#11
05-02-14, 23:52
|
|||
|
|||
Ric Davies
G'day Dale, yep your seals look spot on and mine are doing a good job 3years on. With the bearings I replaced 5 and reused the rest. I put the best of them into the 4 displacement wheels due to the side load when steering. I think small pits in the bearings will be ok well lubed, my worst had probly had a good mm of side play at the centre and are in the rear road wheels. You would have to put the seal carriers on the end of a piece of heavy pipe close to the same OD then a smaller piece on the inside of it and don't be shy with the hammer.
Good job with the project. Ric
__________________
42 Jeep & GMH Trailer (restored) CJ3B Jeep (restored) WLA Harley (restored) WM20 BSA (restored) Chev Radio Van (restored) Universal Carrier (restored) FWD HAR-1 (restored) Ferret Scout Car (operational unrestored) Ford F60 Blitz 4x4 (drive able unrestored) Chev C60X 6x6 (drive able unrestored) Studebaker 6x6 (drive able unrestored) 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Lynn Eades 
Threaded Mode