|
|
#17
09-03-14, 17:20
|
|||
|
|||
As Lynn recalls, correctly, the TL 1623 and TL 1624 (or CTL) rings are located on either side of the double bogie assembly. The outer one is quite obvious, however, the inner one may be lurking close to the leather dust excluder. If it is not rusted in place, you should be good to go. A touch of heat and some lube works wonders. Don't forget to remove the leather dust excluder wiring!
There is no need to remove the TL 1613 cross tube rollers when re/re the cross tube. The procedure is published in the British AOP maintenance manual. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A slow way to remove paint | Keith Webb | The Restoration Forum | 2 | 24-09-12 08:14 |
| You tube | Ledsel | The Carrier Forum | 3 | 03-04-08 03:01 |
| A Rattling Good Read -- Remove if old news | Bob Potter | WW2 Military History & Equipment | 2 | 11-11-07 01:49 |
| UC Cross Tube Gaitors | Stewart Loy | The Carrier Forum | 25 | 17-08-06 16:46 |
Threaded Mode