|
|
|
|
#1
16-04-14, 10:06
|
|||
|
|||
Hi Rich. I recon I almost recognize that spall strip, or at least the origin of the cad drawing for it?(If they were an exact copy, all would be the same anyhow. I'm just guessing you might have had some help?) Suggest before you rivet that you shim both ends so there is room for the paint, if you haven't already thought of it.
You are progressing well. Keep it going!
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... 
|
|
#2
16-04-14, 10:14
|
||||
|
||||
|
Thanks, I had hand painted some etch primer on the surfaces that mate together then set the rivets.... Two of them I am annoyed about... I have marked the steel by not watching closely enough.
By the time the numerous layers of paint go on it shouldn't be so bad, failing that I will polish the scars out
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
