![]() |
|
#1
|
|||
|
|||
![]()
Rich, I think there is a piece welded into the curves at the end, so that a bolt (c/sunk screw or 2) can come in from the end of each air duct to hold it. if you follow.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#2
|
|||
|
|||
![]()
Plate-engine ventilator deflector TL 7252 and fitting
|
#3
|
||||
|
||||
![]()
Rich, I have emailed you pics of both items, do you need all the hole location dimensions?, for starters it a piece of 2" angle iron 3/8" thick, get a piece as wide as your carrier.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. |
#4
|
|||
|
|||
![]()
Thanks Michael. Very helpful of you. Photos are great!
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#5
|
||||
|
||||
![]()
Yep, cheers guys that helps me loads !
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). |
#6
|
||||
|
||||
![]()
That dimension might be 1/4" will check.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. |
#7
|
||||
|
||||
![]()
Cheers guys !
Hopefully I should roll her out next week when I get back from Suffolk ! And get the engine pack installed. I still need to make the fuel tank floor mounts, which look like they may be a bit of a nightmare... Was thinking about flattening one and getting it copied for laser cutting. Worst case scenario being I just run the machine from a jerry can for W&P
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). |
![]() |
Thread Tools | |
Display Modes | |
|
|